Taubmans All Weather Low Sheen is suitable for all exterior walls and surfaces including timber, masonry and galvanised iron.
Ensure surfaces to be painted are clean, dry and free of contamination. In hot and windy conditions or when painting very absorbent surfaces, dampen the surface with water before painting.
Timber - Weathered (greyed) timber must be sanded to original timber surface. Tannin rich timbers such as cedar should be primed with Taubmans Prep Right Wood Primer or Taubmans 3 in 1
Galvanised Iron - Thoroughly degrease new surfaces. Weathered surfaces should be thoroughly cleaned before painting. For structural galvanised iron, abrade with 240# paper to remove chemical treatments and allow full adhesion.
Cement Render/Concrete - Allow concrete, cement render and mortar to cure for 28 days before painting.
Steel - Remove rust and prime with Taubmans Prep Right Iron and Steel Primer or White Knight Metal Primer.
Apply two liberal coats by brush, roller or spray. Do not overspread. Keep brushes and rollers working freely by rinsing occasionally in clean water.
Water, away from drains.
Up to 16må_/litre, depending on nature of surface. Coverage will be lower on rough or absorbent surfaces.
Recoat after 2 hours at 25å¡C and 50% relative humidity.
Stir paint with a 25mm wide flat stirrer in a circular lifting motion for at least 5 minutes before use.
Do not use at temperatures below 10å¡C, above 35å¡C or when humidity is excessive.